Manual Diagnostic Test for Maytag Epic Z Washer

Here are instructions on how to run a Manual Diagnostic Test for Maytag Epic Z Washer

Start the Test by Closing the door

Select any one  key/button (except the PAUSE/CANCEL) and follow the steps below using the same key.

a. Press then hold for 4 seconds

b. Release for 4 seconds

c. Press then hold for 4 seconds

d. Release for 4 seconds

e. Press then hold for 4 seconds

f. Release for 4 seconds

g. Press then hold for 4 seconds

h. Release

NOTE: Press the same key to advance to the next failure code.

At the end of the procedure the program will loop back to the beginning. This is a continuous loop. To cancel out of the Manual Test More press the PAUSE/CANCEL button.

Leave comments below if you have questions about Manual Diagnostic Test for Maytag Epic Z Washer